I picked some Burger Juggernauts up for load testing out of my SRS, 22" original Gen 1 Krieger barrel. Although not as accurate as the 175gr VLD Hunters out of my rifle so far these aren't horrible and maybe with a little seating adjustment may actually work. The testing was done at 119 yards, with Varget powder, Federal case, CCI200 primers, and the bullets set to 2.850". All loads were shot from prone with a bipod and rear squeeze bag. I loaded from minimum to maximum (for my rifle) and picked a load that looked the most consistent. Then I took that load and 5 at -.2gr and then 5 at +.2gr. From here I'll pick a load, probably the -.2gr load, and work on seating depth. I'll update with new pick and thoughts later. Any thoughts or suggestions are welcome!
Loads were shot lowest to highest, left to right.
Primer cratering is very normal for my rifle as it will show even with the lightest loads. Also the circular marks on the case heads are from the primer pocket uniformer.
1 post • Page 1 of 1